Table of Contents
Advertisement
7
Loading the material
Front vinyl
Material tray
squeegee
Alignment
line
Roll rests
Left roll hub
Right roll hub
and motor
The rolls of MAXX READY material are mounted on the roll hubs at the front of the printer.
There is a material loading path illustration on the left material roll hub for guidance in loading
material. Under the roll hubs are roll rests to aid in loading heavy rolls of material.
The left roll hub is stationary, while the right roll hub slides across the front of the base to
accommodate the slight variations in width of the supply roll. The left roll hub is motor-driven
to provide a loop of material, which reduces drag while the material advances through the
printer. When the loop is the correct size, the motor is off.
Before loading the material, lift the material tray up and lock it in the horizontal position. On
the left side of the tray is an alignment line. There is another alignment line on the back of the
table where the vinyl exits. When you load the material, align the left side of the material with
both of these lines before clamping the material with the magnet bars.
Advertisement
Table of Contents
