Table of Contents
Advertisement
Error message
Meaning
Disk Full Error
The MAXX 2 cannot allocate sufficient
contiguous disk space to store print jobs
before printing.
DSP A Positioning
The A-axis motor has synched out
Error
resulting in an A-axis position loss.
DSP Command NAK
There may be a problem between the
PC and the DSP card.
DSP Command
There may be a problem between the
Synch Error
PC and the DSP card.
DSP Dataseq Error
There may be a problem with the PC
and the DSP card.
DSP Fire Pulse Error
This error usually occurs when an old
version of OMEGA or GA has been used
to create the job. When the error is
detected, the job is discontinued.
DSP State Error
There may be a problem with the DSP
board or computer.
DSP Thermal Error
The print head is outside the legal range
of 0 to 60
DSP Y Positioning
The Y-axis motor has synched out
Error
resulting in Y-axis position loss.
DSP Z Positioning
The Z-axis motor has synched out
Error
resulting in Z-axis position loss.
Edge Tracking Error
Check material for ragged or bent
edges.
Error Getting Data
Indicates a firmware fault, or a host –
Socket
MAXX 2 interface fault.
Error Mounting Disk
There may be a problem with the
computer hard disk.
Error Opening Data
This error indicates a firmware fault, or a
Connection
host-MAXX 2 interface fault.
Error Opening
The thermistor compensation table file
TCOMP
could not be opened.
Error Reading Job
The job file is corrupted or truncated.
Data
Error Setting Voltage
The MAXX 2 printer cannot set the TPH
power supply to the correct voltage on
power-up.
Error Writing
Error occurs when writing to the
EEPROM
EEPROM on the TPH buffer board
o
o
C (0 to 140
F).
Action
Space becomes available when each
print job finishes. If the error persists
even after all print jobs are finished,
power should be cycled off/on.
Contact Gerber Field Service.
Contact Gerber Field Service.
Contact Gerber Field Service.
Contact Gerber Field Service.
Load the current version of OMEGA, re-
render the job and re-send it to the
printer.
Contact Gerber Field Service.
Contact Gerber Field Service.
Contact Gerber Field Service.
Contact Gerber Field Service.
Replace vinyl. If error still occurs, there
may be a bad sensor. Contact Gerber
Field Service.
Cycle power. If error still occurs contact
Gerber Field Service.
Contact Gerber Field Service.
Cycle power. If error still occurs, contact
Gerber Field Service.
Contact Gerber Field Service.
Re-render the job and re-send it to the
printer.
Cycle the MAXX 2 power. If error still
occurs, contact Gerber Field Service.
Contact Gerber Field Service.
47
Advertisement
Table of Contents
