Table of Contents
Advertisement
48
CHAPTER 7
Understanding Messages
Error message
Foil Write Error, Bay
"#"
Foil Write Verify
Error
Illegal Command in
Job
Illegal Data
Compression
Illegal Job Format
Internal Y Position
Error
Material Twisted
Missing Fire Control
Data
Missing History
Control Data
Reminder to Change
Head Cleaning Pad
Time Out Sending
Command
Time Out Waiting
For A Stop
Time Out Waiting for
Axes Stop
Meaning
Unable to write the foil button in bay
"#" after unloading that foil.
Cannot read foil button to verify what
was just written.
Firmware encountered an unknown
command in the job data. The job is
aborted.
The job compression format is
unknown. The MAXX 2 accepts only
jobs that are compressed in LZW format
or uncompressed image data. The job
is aborted.
This usually occurs when an old version
of OMEGA or GA has been used to
create the job. Job is aborted.
Vinyl has shifted too far to the left of the
guide mark during a print job.
The material may not be perfectly
straight. The job pauses.
Embedded fire control information is
not in job. This usually occurs when an
old version of OMEGA or GA has been
used to create the job. Job is aborted.
Embedded history control information
not in job. This usually occurs when an
old version of OMEGA or GA has been
used to create the job. Job is aborted.
Displayed to remind the user to remove
the used the head-cleaning pad.
PC fails to receive acknowledgement in
a reasonable amount of time
PC fails to receive notification of the
A-axis stop in a reasonable amount of
time.
PC fails to receive notification of the
axes stop in a reasonable amount of
time.
Action
Ensure the cassette is properly seated in
the bay, and tap the supply roll to
correct a possible contact problem with
the button. If error still occurs, try
loading a different foil. If error goes
away, the button on the first foil is bad.
Ensure the cassette is properly seated in
the bay, and tap the supply roll to
correct a possible contact problem with
the button. If error still occurs, try
loading a different foil. If error goes
away, the button on the first foil is bad.
Re-render the job and re-send it to the
printer.
Re-render the job and re-send it to the
printer.
Load the current version of OMEGA,
re-render the job and re-send it to the
printer.
Check the vinyl edge for damage.
Replace vinyl. If the error still occurs, the
vinyl sensors may be dirty. Contact
Gerber Field Service.
You can continue printing at your own
risk or stop the job, fix or replace the
vinyl and reprint job.
Load the current version of OMEGA,
re-render the job and re-send it to the
printer.
Load the current version of OMEGA,
re-render the job and re-send it to the
printer.
Remove the topmost head-cleaning
pad.
Cycle power. If error continues, contact
Gerber Field Service.
Cycle power. If error continues, contact
Gerber Field Service.
Cycle power. If error continues, contact
Gerber Field Service.
Advertisement
Table of Contents
