Table of Contents
Advertisement
Straightening wrinkles in foil
After loading the foil cassettes, inspect them to ensure that the foil is not folded over on itself (as
shown below). If the foil folds over on itself, it will cause wrinkles on the print. To unfold the
foil, push the foil with your fingernail while rotating the take-up roll (the top roll)
counterclockwise.
Loading the cassettes in the MAXX 2
Once the foil is loaded into the cassettes you can load up to six cassettes into the cassette rack.
To load the cassette in the cassette rack
Cassette bays
1 Raise the transparent cassette rack cover.
2 Tilt one of the cassette bays out and away from the front of the table.
3 Lay the cassette in the bay as shown in the photo, then push it toward the inside of the
table until it touches the bay stops.
4 Carefully lift the cassette bay so that it is vertical and the cassette is in the table area.
5 Close the cassette rack cover.
Note: All the cassette bays in the rack must be vertical and the cassette rack cover must be
closed or the printer will not operate.
Bay stop
Take-up roll
Put fingernail under
fold, to straighten foil,
and wind foil onto
take-up roll
Cassette
11
Advertisement
Table of Contents
