Table of Contents
Advertisement
Chapter 6:
Modifying MAXX 2 Print Settings
Your MAXX 2 is optimized at the factory to produce high quality prints. If you suspect that
your MAXX 2 is out of calibration, you can print several calibration check prints that are
resident in the MAXX 2. You can also fine tune printhead settings for individual materials by
modifying Print Darkness or Seam Adjust. Take care when adjusting factory default settings. If
you have questions about your MAXX 2 print settings, contact Gerber Field Service.
Printing the Pull Out or Pull Back Check prints
The Pull Out or Pull Back check prints are designed to assist a Gerber technician in determining
if your MAXX 2 requires adjustment. The Pull Out and Pull Back Check prints must be printed
on 225 white vinyl only. Using a different substrate may provide erroneous results. After
printing the check prints, contact Gerber Field Service for assistance.
To print the Pull Out or Pull Back Check prints
1 Load a roll of 225 white vinyl in the MAXX 2.
2 Press MENU on the control panel. The display is:
< Bay Status
< Job Queue
< Setup
< Service
3 Press the function key for
< Run Test Job
< Calibration
< System Update
4 Press the function key for
< Calibrate Material Pull
< Calibrate Print
5 Press the function key for
< Print Pull Out Check
< Print Pull Back Check
< Print Long Pull Back Check
6 Press the function key for calibration check print that you want to print. The display
changes to:
Busy Printing Calibration Image...
7 When the job is complete, contact Gerber Field Service for instructions.
. The display is:
< Service
. The display is:
< Calibration
. The display is:
< Calibrate Material
39
Advertisement
Table of Contents
