Table of Contents
Advertisement
4
CHAPTER 2
Getting to Know the GERBER MAXX 2
printing as water or moisture can damage the printhead. Before loading vinyl into the MAXX 2,
wipe the ends of the roll with a tack cloth to remove any dirt or dust.
Vinyl storage
When not in use, vinyl should be stored in the original plastic bag to protect it from dust and
dirt. Save the original box for long-term storage of vinyl rolls. Never store the vinyl lying down
or in the MAXX 2 material catching baskets, which can leave impressions on the surface of the
vinyl. Store the vinyl standing on the end of the roll that will be opposite the edge sensors at the
left side of the MAXX 2. Standing the roll on the end that will be used to align the vinyl can
cause print quality problems. To protect the material from the floor, stand the roll on the plastic
plug included with the original packaging.
Backing
sheet side
of vinyl
Stand the roll on this end to avoid
damaging the end of the roll that the
MAXX sensor uses to align the vinyl.
Stand the roll on the plastic plug
included with the original packaging.
Advertisement
Table of Contents
