Chapter 5: Printing Jobs; Setting Up And Sending The Job; Determining The Status Of Each Bay - Gerber MAXX 2 Owner's Manual

Chapter 5:
Printing Jobs
This chapter describes the process of printing jobs on the GERBER MAXX 2. It covers the
following topics.

♦ Setting up and sending the job

♦ Determining the status of each bay

♦ Printing the job
♦ Printing test jobs
Setting up and sending the job
Jobs are set up and sent to the MAXX 2 in the GSPPlot program. The MAXX 2 is capable of
printing any job file that can be opened in the GSPPlot program of OMEGA 1.56 or higher or
that has been rendered and saved as an SPL file. For a complete list of usable file types, click on
the down arrow beside the Files of type list box in the GSPPlot Open dialog box.
After you open a job in GSPPlot, you can use all the features of the program to set up the job
(such as rotate, panel, and repeat, for example). To use the GSPPlot program, refer to the
GSPPlot Help system.
After the job is set up, click on the print button to send the job to the MAXX 2.
Determining the status of each bay
The Bay Status display shows you the name of the foil and amount of foil in each bay.
To view the Bay Status
1 Press MENU to display the Main menu.
< Bay Status
< Job Queue
< Setup
< Service
2 Press the function key for
bays. Following is an example of a typical display.
Bay Inches Description
1
< 2 4759
< 3 2590
< Bay Status
empty
PROCESS CYAN GCP-707
PROCESS YELLOW GCP 705
. The display shows the status of the first three
33