Table of Contents
Advertisement
30
CHAPTER 4
MAXX 2 Care and Cleaning
2 Rub the printhead element strip or bead with the dull, abrasive side of the pink
cleaning film. Be certain to rub the entire width of the bead all the way out to each
edge. Use about one pound of pressure when rubbing and rub the width for
approximately 10 strokes.
Tip: Save the used pink cleaning film for cleaning the cassette. Do not use it again to clean the
printhead.
3 Using the pre-moistened alcohol pad from the cleaning kit, rub the peel bar, printhead
elements, the green strip area between the bead and the insulation. Do not clean the
circuit card. Rub the entire width all the way out to each edge approximately 10
strokes. You may refresh the alcohol pad with 99 percent isopropyl alcohol if the pad
becomes dry when cleaning.
Peel bar
Bead or print
element
Green strip
between bead
and insulation
Black insulation
Circuit card
Advertisement
Table of Contents
