Table of Contents
Advertisement
44
CHAPTER 7
Understanding Messages
Message
Close All Bays to Proceed
Close Cover(s) to
Proceed
Cooling Print Head...
Cycle Printer Power
Off/On
Detected vinyl too small
End of Vinyl Error
Enter Pull Distance
Error Setting Voltage
Error: - Queue Full
Foil Low, Bay X
Foil Very Low, Bay X
Foil Out, Bay X
Foil Broken, Bay X
Initializing...
Job Ready
Job Refused – Host
Submit Active
Job Waiting to Print
Load More!
Load specified foil
Load specified vinyl
Loading Cassette...
No vinyl detected
Type
Comment/Action
P/A
A cassette bay is open. Close the bay.
P/A
A cover is open. Close the cover.
I
Printhead temperature exceeds the range; this message clears when
printhead temperature is correct.
P/A
An unrecoverable error has occurred during printing. Turn the MAXX
2 off and on.
P/A
Appears if the vinyl width is too small for the job dimensions; reload
correct vinyl.
P/A
The vinyl has run out. Replace vinyl and reprint job
P/A
Appears if you press and hold the UP or DOWN key; use the UP and
DOWN keys to change the amount of vinyl pulled across the platen
when slewing; the default is 16".
I
May occur during power up. Reboot system. If message continues,
call Gerber Field Service.
I
The Job Queue is full. The MAXX 2 can store up to 32 jobs. See
"Deleting jobs from the queue" on page 18.
P/A
Displayed prior to loading the cassette. There is between 2% and
7% of the length of a full roll of foil in the cassette and the amount
remaining is less than required for the job. Press RUN to continue or
replace the foil in the cassette and then press RUN.
P/A
Displayed prior to printing a swipe. There is less than 0.1% of the
length of a full roll of foil in the cassette. Press RUN to continue or
replace the foil in the cassette and then press RUN.
P/A
The cassette in Bay X is out of foil. The MAXX 2 is paused. Replace
the foil in the cassette and press RUN to continue.
P/A
The foil in Bay X is broken. The MAXX 2 is paused. Repair or replace
the foil in the cassette and press RUN to continue.
I
Appears during power up.
A job has been sent to the printer. Press a RUN key to start the
I
printing sequence.
I
Displayed when print jobs have been queued from a remote
computer and a test job is queued to print.
I
Appears after a job is sent and before RUN is pressed.
P/A
Appears if you press the function key for foil after a job is sent and
there is not enough foil to print the job.
P/A
A foil required for the job is not loaded in the cassette bays. Load the
foil.
P/A
The vinyl required for the current job is different from the last job
printed or there are vinyl load errors. Load vinyl.
I
Appears while loading a cassette (followed by the color name).
I
Appears if the printhead alignment sensor can not detect the right
edge of the vinyl at the start of a job.
Advertisement
Table of Contents
