4.4 Guide Plates on the Folder
1
2
3
20
With the needle bar link in the most forward position the edges 1 of the
guide plates must extend approx. 1 mm to the back beyond the
needles.
Depending on the material thickness and whether the flap is to be
positioned right or left, the height of the guide plates 2 is to be set so
that the spring-mounted holder 3 can easily be lifted by the material.
1 mm
Caution Risk of Injury !
Turn the main switch off.
Set the guide plates only with the main switch turned off.
–
Loosen screw 4 and 5.
–
Set the guide plates 1.
–
Tighten screw 4 and 5 again.
4
5