Setting The Edge Stop Parameter (Edge Guide); Setting The Correction Of Effects Of High Speed Parameter (Speed Corr.) - Duerkopp Adler 867-M PREMIUM Operating Instructions Manual

74

5.4.11 Setting the Edge stop parameter (Edge Guide)

The edge stop helps to precisely position the sewing material.
The value set indicates the distance between the needle and edge
stop/material edge.
nd
The 2 distance for the edge stop can only be accessed using
the softkey menu button or the softkey button if these are
nd
assigned to the 2
Menu item
Gap
Edge stop
Gap (+)
nd
Edge stop 2 Distance
5.4.12 Setting the Correction of effects of high speed
parameter (Speed Corr.)
Some parameters are affected by high speeds because of the
resulting physical effects. To counteract these effects and to
achieve consistent results, even at high speeds, adjustment
factors can be set depending on the speed.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
Menu items Setting option 1
ON/OFF
Stitchlen., Off
Stitch length
 p. 77
linear
2.OnOff
2.On
Operating Instructions 867-M PREMIUM - 02.0 - 05/2017
distance.
Setting option
Value range 01.0 – 45.0 [mm]
Value range 01.0 – 45.0 [mm]
Programming
Setting option 2
Stitchlen.
Min. speed
Max. speed
Min. speed
Min. speed