Center knife movement
The center knife must move counter to the needle bars.
When the needles lie at their lower dead center the knife bar drive
lever 1 must be at the upper dead center.
1
–
Tilt the machine head up to the side.
–
Loosen clamping screws 2.
–
Turn the eccentric 4 so that the center knife moves counter to the
needle bars.
–
Tighten clamping screws 2.
–
Loosen clamping screws 3.
–
Turn the counter disc 5 into the same position as the eccentric 4.
The clamping screws of the eccentric 4 and of the counter disc 5
must lie inline.
–
Tighten clamping screws 3.
–
Tilt the machine head down.
2
3
4
5
95