2.2 Forward End Position
2
6
The switch S25 determines the forward end position of the transport
carriage. In this position the clearance x from the front edges of the
forward-lying needles to the front edges 2 of the transport clamps must
be:
x = 336 mm at 180 mm sewing distance
x = 376 mm at 220 mm sewing distance
The switch S15 serves as a safety switch. It prevents a possible
striking of the transport carriage on the machine head.
The clearance between the switches S25 and S15 must be approx.
90 mm.
Checking the switch position
–
Turn the main switch on.
–
Step forward on the left pedal.
The transport carriage runs to its forward end position.
Hereby it runs over the switch S25 (reference position).
After a further run of approx. 80 mm it stops in the forward end
position.
–
Check the clearance x from the front edge of the forward-lying
needles to the front edges 2 of the transport clamps.
Correcting the switch position
Caution Risk of Injury !
Turn the main switch off.
Correct the position of the switches S15 and S25 only with the main
switch turned off.
–
Remove the cover plate after loosening the mounting screws.
–
Set the switches S15 and S25 after loosening the clamping screws.
–
Tighten the clamping screws again.
S25
S15