3.4 Guide Plates on the Folder
1 mm
2
With the needle bar link in the most forward position the edges 2 of the
guide plates must extend approx. 1 mm to the back beyond the
needles.
The leaf springs 1 hold the guide plates down on the folder sole with a
slight pressure.
The pressure must be so calulated that the spring-mounted guide
plates can be easily raised by the entering piping strip or flap.
1
3
Caution Risk of Injury !
Turn the main switch off.
Correct the guide plates only with the main switch turned off.
–
Loosen screws 3 ( 2-off ).
–
Loosen set screw 6.
–
Set the guide plates in the lengthwise direction.
In the forward needle position the edges 2 of the guide plates must
extend approx. 1 mm to the back beyond the needles.
–
Tighten set screw 6.
–
Set the set screw 5 ( 2-off ).
The lower edges of the guide plates should be approx. 1 to 2 mm
above the cloth slider plate.
–
Tighten screws 3 ( 2-off).
–
Loosen screws 4 ( 2-off ).
–
Set the pressure by aligning the leaf springs 1.
–
Tighten screws 4 ( 2-off).
1
4
5
6
5
3
15