Marker Lights - Duerkopp Adler 745-26 Service Instructions Manual

11. Marker Lights

1
141
1 : Needles forward
2 : light marker - forward positioning point
3 : 3rd marker light (on request)
56
The light markers 2 and 4 limit the sewing area.
Alternatively, a 3rd marker light, which can be supplied on request,
can be attached (Order no. see Table).
Subclass Order no.
745-26 0794 003031
745-28B
745-28D
745-28F
745-28A 0794 022068
The multifaceted mask built into the lamp optics makes possible the
following applications:
–
Via the small H-light markers a clearance of 10 mm between
breast dart and flap edge can be achieved when positioning jacket
fronts.
By setting the marker lights higher, the clearance can be increased
to a maximum of 15 mm.
–
Turn the marker light 90°.
By setting it higher or lower, clearances from 15 mm up to a
maximum of 25 mm can be set with the large H-light marker.
2 3
10
180 - 220
After raising or turning the marker lights it is essential to observe the
following points:
–
Reset the lamp holder.
–
Align the light markers congruent to the center of the pocket
opening.
–
Keep to the maximum sewing area.
Focusing the light markers
–
Loosen clamping screw 14 slightly.
–
Focus the light marker by setting the tube 13 higher or lower.
–
Tighten clamping screw 14.
4
10
4 : Light marker - rear positioning point
5 : Center of the pocket opening
6 : Reference line
5
6