Positioning Device For Work Method D - Duerkopp Adler 745-26 Service Instructions Manual

7. Positioning Device for Work Method D

1
36
The breast selvage lying on the placing table is taken by the
positioning device and positioned over the, at first, roughly aligned
jacket front.
This makes possible pattern-perfect alignment and a subsequent
sucking-on of the jacket front by the vacuum.
After the transport clamps have lowered onto the front, the breast
selvage is lifted again, reversed and moved to the flap clamp.
The maximum sewing distance for breast selvage pockets is 145 mm.
Caution Risk of Injury !
Turn the main switch off.
Set the positioning device only with the main switch turned off.
Conduct setting work with the sewing machine running only while
exercising the greatest possible caution.
Aligning the folder
The folder is to be aligned exactly as described for the Work Method
B, C in the Chapter 4.
Aligning the positioning device
The positioning device 6 is mounted on the the seating pin 1.
–
Align the seating pin 1.
Description see Chapter 4.6 Gripping Folder.
–
Attach a DIN A4 sheet of paper to the slider plate.
Mark the line for the center knife incision.
Draw a parallel 2nd line at half the needle spacing distance.
The left seam runs along the left line.
–
Place the positioning device 6 on the seating pin 1 and align
parallel to the lines. Tighten screw 3.
–
Loosen screws 2 and 4.
–
Align the left edge of the clamp 5 congruent to the left line.
–
Tighten screws 2 and 4.
2 3 4 5 6