Sewing Trial To A Pattern - Duerkopp Adler 745-26 Service Instructions Manual

8.3 Sewing Trial to Pattern
48
After the base settings have been made according to these service
instructions the pattern-perfect setting is made with an accordingly
prepared sewing piece of light-colored material.
1
–
Draw lengthwise and crosswise lines on flap 2 and the sewing
piece.
–
Position the piping strip.
–
Position flap 2 on the parallelly aligned stop 1.
Set the stop so that the flap lies approx. 10 - 15 mm beyond the
base line to the left.
–
Align the sewing piece.
The lengthwise and crosswise lines of the sewing piece and the
flap must be congruent.
–
Conduct a sewing sequence.
–
Remove the sewing piece and reverse it.
–
Check the sewing trial and correct faulty sewing results.
( see Chapter 8.4 )
2 2