Table 1-17. Group 2 Features (Esc/P Mode) - Epson FX-870 Service Manual

To change the settings shown in Table 1-17, Group 2 Features (ESC/P mode), or in
Table l-18, Group 2 Features (7BM mode), follow the steps below:
1. Turn on the printer while pressing the FONT and PAUSE buttons. The printer
beeps once and prints the current character table for either ESC/P or IBM mode
on the paper loaded in the paper path.
2. Press the FONT button to select the character table. The FONT, CONDENSED,
and BEADY LEDs turn on, off, or blink to show your selection. Press the FONT
button as many times as necessary until the FONT, CONDENSED, and BEADY
3. Turn off the printer. The settings are stored in non-volatile memory.
OFF OFF
OFF OFF
OFF ON
OFF ON
OFF
ON
BLINKS
OFF
OFF BLINKS
OFF BLINKS
ON OFF
ON OFF
ON OFF
ON ON
ON ON
ON ON
ON BLINK
Note: When the character table PCxxx is selected, that is assigned as the table
selected by the,ESC tl command. Then ESC tl and ESC 6 are set as defaults.
(Codes 80-9FH are printable characters.)
Epson FX-870/1170
1-17.
ON I t a l i c
BLINKS
OFF
ON
BLINKS
OFF
ON
BLINKS
OFF
Character table
ON
BLINKS
OFF
ON
BLINK
OFF
Printer Features
Character Table
U.S. (standard setting)
France
Germany
U.K.
Denmark
Sweden
Italy
Spain
PC437
PC850
PC860
PC863
PC865
Abicomp
I
1-21