Configuring Lan And Wireless Access - NETGEAR WNDAP350 - ProSafe 802.11n Dual Band Wireless Access Point User Manual

ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual
2. Configure the computer with a static IP address of 192.168.0.210 and 255.255.255.0 for the
Subnet Mask.
3. Connect an Ethernet cable from the WNDAP350 to the computer.
4. Turn on your computer, connect the power adapter to the WNDAP350 and verify the
following:
• The PWR power light goes on.
• The LAN light of the wireless access point is lit when connected to a powered on
computer.
• The WLAN LEDs should be blinking.

Configuring LAN and Wireless Access

To configure the WNDAP350 Ethernet port for LAN access:
1. Connect to the WNDAP350 by opening your browser and entering http://192.168.0.237 in the
address field. The WNDAP350 login screen appears (see
2. Enter admin for the user name and password for the password, both in lower case letters.
Figure 2-2 Login screen
3. Click Login. The main menu of the WNDAP350 displays as shown in
• When the wireless access point is connected to the Internet, under the Support tab, select
Documentation to view the documentation for the wireless access point.
• On the top-right of the screen, select Logout to exit the WNDAP350 setup screens. (You
will automatically be logged out of the wireless access point after 5 minutes of no
activity.)
Basic Installation and Configuration
v1.1, November 2009
Figure 2-2).
Figure 2-3.
2-5