Restricting Wireless Access By Mac Address - NETGEAR WNDAP350 - ProSafe 802.11n Dual Band Wireless Access Point User Manual

ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual

Restricting Wireless Access by MAC Address

The optional Access Control window lets you block the network access privilege of any specified
stations through the WNDAP350 wirelss access point. When you enable access control, the access
point only accepts connections from clients on the selected access control list. This provides an
additional layer of security.
Note: If configuring the WNDAP350 from a wireless computer whose MAC address is
not in the access control list, if you select Turn Access Control On, you will lose
your wireless connection when you click Apply. You must then access the
wireless access point from a wired computer or from a wireless computer that is
on the access control list to make any further changes.
To restrict access based on MAC addresses:
1. Log in to the WNDAP350 using the default address of http://192.168.0.237, user name of
admin and default password of password, or whatever LAN address and password you have
set up.
2. Under the Configuration tab, select Security on the main menu, select Advanced from the
left panel, and then select MAC Authentication. The MAC Authentication screen displays.
2-44
v1.1, November 2009
Basic Installation and Configuration