NETGEAR WNDAP350 - ProSafe 802.11n Dual Band Wireless Access Point User Manual page 38

ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual
1. From the main menu under Configuration, select Wireless, and then select the 802.11a/na
tab. The Wireless Settings screen for your 11a/na access point displays as shown in
11 below.
Figure 2-11 Basic Wireless Settings - 802.11a/na
2. Configure the Wireless LAN settings based on the following field descriptions:
• Wireless Mode. Select the desired wireless operating mode. Only 802.11a/na wireless
modes can be selected from this menu. The default is 11na. The options are:
– 11a – All 802.11a wireless stations can be used.
– 11na – All 11a and 11na wireless stations can be used. This is the default.
Note: If you select one of these options and if other settings on this
• Turn Radio On. On by default, you can also turn off the radio to disable access through
this device. This can be helpful for configuration, network tuning, or troubleshooting
activities.
• Wireless Network Name (SSID). This is the name of your wireless network. It is set to
the default name of NETGEAR_11a for 802.11a/na and NETGEAR_11g for 802.11b/bg/
ng modes.
2-18
screen are disabled, then you must select the Turn Radio On
radio button to enable available options on this screen.
v1.1, November 2009
Basic Installation and Configuration
Figure 2-