Using The Reset Button To Restore Factory Default Settings - NETGEAR WNDAP350 - ProSafe 802.11n Dual Band Wireless Access Point User Manual
Prosafe dual band wireless-n access point
Hide thumbs
Also See for WNDAP350 - ProSafe 802.11n Dual Band Wireless Access Point:
- Reference manual (138 pages) ,
- Product data (2 pages) ,
- Application note (6 pages)
Table of Contents
Advertisement
ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual
Using the Reset Button to Restore Factory Default Settings
The Reset button (see
•
Reboot. When pressed and released quickly, the WNDAP350 will reboot (restart).
•
Reset to Factory Defaults. This button can also be used to clear ALL data and restore ALL
settings to the factory default values.
To clear all data and restore the factory default values:
1. Power off the WNDAP350 and power it back on.
2. Use something with a small point, such as a pen, to press the Reset button in and hold it in for
at least 5 seconds.
3. Release the Reset button.
The factory default configuration has now been restored, and the WNDAP350 is ready for use.
5-4
"Rear Panel" on page
v1.1, November 2009
1-8) has two functions:
Troubleshooting and Debugging
Advertisement
Table of Contents
