NETGEAR WNDAP350 - ProSafe 802.11n Dual Band Wireless Access Point User Manual page 52

ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual
To configure a Security Profile:
1. From your Web browser, log in to the WNDAP350 using the default LAN address of
http://192.168.0.237, user name admin and password password, or use the LAN address and
password that you set up.
2. Under the Configuration tab, select
Security Profile Settings for 802.11b/bg/ng or 802.11a/na. The screen for the Profile Settings
you selected displays as shown in
3. Select the check box of the profile you want to modify and click Edit. The Security Profile
Configuration screen for the selected profile displays (see
Figure 2-16 Edit a security profile
4. Give your profile a meaningful name so that you can remember it later.
5. The Wireless Network Name (SSID) is set by default to identify it as NETGEAR_11g.
6. Enable or disable the Broadcast Wireless Network Name (SSID). It is enabled by default. (If it
is broadcast, it can be easily detected by other clients.)
7. From the Network Authentication pull-down menu, select the Network Authentication Type
you want to use for this profile:
• To configure WEP encryption for Open Systems or Shared Key, see
on page 2-33.
2-32
Security from the main menu, and then select either
Figure 2-15above.
v1.1, November 2009
Figure 2-16).
"Configuring WEP"
Basic Installation and Configuration