NETGEAR WNDAP350 - ProSafe 802.11n Dual Band Wireless Access Point User Manual page 75

ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual
Figure 3-7 Restore to factory defaults
2. On the Restore Defaults screen, enable the Restore to factory default settings option by
selecting the Yes radio button.
3. Click Apply to reset to the factory default settings.
After a restore, the wireless access point password will be password, the default LAN IP address
will be 192.168.0.237, and the access point name will reset to the name printed on the label on the
bottom of the unit.
To restore the factory default configuration settings without knowing the login password or IP
address, you must use the Default Reset button on the rear panel of the wireless access point (see
Figure 1-1 on page 1-7). The reset button has two functions:
• Reboot. When pressed and released, the Wireless Access Point will reboot (restart).
• Reset to Factory Defaults. This button can also be used to clear all data and restore all
settings to the factory default values.
To clear all data and restore the factory default values:
1. Power off the WNDAP350.
Management
v1.1, November 2009
3-9