Table of Contents
Advertisement
ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
Installing the WNDAP330 Wireless Access Point
Before installing the ProSafe 802.11n Dual Band Wireless Access Point WNDAP330, you should
make sure that your Ethernet network is up and working. You will be connecting the access point
to the Ethernet network so that computers with 802.11b/g/n or 802.11a/n wireless adapters will be
able to communicate with computers on the Ethernet network. In order for this to work correctly,
verify that you have met all of the system requirements, shown on
page
1-6.
Setting up the WNDAP330 Wireless Access Point
Tip: Before mounting the WNDAP330 in a high location, first set up and test the
WNDAP330 to verify wireless network connectivity.
To set up the WNDAP330 Wireless Access Point:
1. Prepare a computer with an Ethernet adapter. If this computer is already part of your network,
record its TCP/IP configuration settings.
2. Configure the computer with a static IP address of 192.168.0.210 and 255.255.255.0 for the
Subnet Mask.
3. Connect an Ethernet cable from the WNDAP330 to the computer.
4. Turn on your computer, connect the power adapter to the WNDAP330 and verify the
following:
•
The PWR power light goes on.
•
The LAN light of the wireless access point is lit when connected to a powered on
computer.
•
The WLAN LEDs should be blinking.
Configuring LAN and Wireless Access
To configure the WNDAP330 Ethernet port for LAN access:
1. Connect to the WNDAP330 by opening your browser and entering http://192.168.0.230 in the
address field. The WNDAP330 login screen will appear.
2-4
Basic Installation and Configuration
v1.0, May 2008
"System Requirements" on
Advertisement
Table of Contents
