Using The Restore Factory Settings Button To Reset The Router - NETGEAR DGN2200v1 Setup Manual

Using the Restore Factory Settings Button to Reset the Router

To restore the factory default configuration settings without knowing the administration password
or IP address, you must press the reset button on the bottom of the router following the steps
below.
Press and hold the Restore Factory Settings button until the Power LED blinks red (about
1.
6 seconds).
2. Release the Restore Factory Settings button and wait for the router to reboot.The Power LED
will blink red three times and then will turn green when the default configuration settings have
been restored.
Troubleshooting 34