Default Configuration And Technical Specifications; Restoring The Factory Configuration Settings; Using The Restore Factory Settings Button - NETGEAR Wireless-N User Manual

RangeMax Dual Band Wireless-N Modem Router DGND3300 User Manual
This appendix provides factory default settings and technical specifications for the RangeMax
Dual Band Wireless-N Modem Router.

Restoring the Factory Configuration Settings

Note: This procedure erases your current configuration, including your wireless security.
When you log in after resetting, you will be prompted to configure these settings.
This section explains how to restore the factory default configuration settings. This procedure
restores the admin user name password to password, and the IP address to 192.168.0.1. You can
erase the current configuration and restore factory defaults in two ways:
• Use the Erase function of the router (see
• Use the Restore Factory Settings button on the rear panel of the router. Use this method for
cases when the administration password or IP address is not known.

Using the Restore Factory Settings Button

To restore the factory configuration settings without knowing the administration password or IP
address, you must use the Restore Factory Settings button on the rear panel of the modem router.
1. Press and hold the Restore Factory Settings button until the Power LED turns red (about 6
seconds).
2. Release the Restore Factory Settings button and wait for the router to reboot.The Power LED
will blink red three times and then will turn green when the default configuration settings have
been restored.
B-1
Default Configuration and Technical
"Erasing the Configuration" on page

Default Configuration and Technical Specifications

v1.0, January 2010
Appendix B
Specifications
4-11).