AT&T MERLIN LEGEND Release 3.0 Installation Manual page 567

Modifying a Release 2.1 or
Earlier Processor for Key Mode
Release 2.1 and Earlier
CAUTION:
This procedure must be performed for KF registration with the FCC.
This procedure prevents the system from being programmed as a
Hybrid-PBX system. Do this only if the system is programmed for Key
mode and GS trunks are not indicated on Form 2c, System
Numbering: Line/Trunk Jacks.
To modify the processor for Permenant Key mode, follow the steps below.
Refer to Figure E-1.
1 Remove the processor from its packaging.
2 Place the processor on a flat surface.
If the feature module is installed, remove it.
3
See "Replacing the Feature Module" in Chapter 4 for instructions.
Maintenance and Troubleshooting E–1
E