AT&T MERLIN LEGEND Release 3.0 Installation Manual page 168

Connecting a Printer to the Control Unit
Connecting a CAT and Printer
on the Same AC Outlet
Use this procedure to connect a CAT and CAT serial printer into the same AC
outlet as the control unit, provided the CAT is fewer than 14 ft. (4.27 m) and
the printer is fewer than 50 ft. (15.2 m) from the control unit.
You need the following hardware for this procedure:
Z200A EMI filter
D8W cord
355A adapter
To connect a CAT and CAT printer on the same AC outlet, follow the steps
below. See Figure 5-3.
1
Plug the short end of the Z200A EMI cord into the SMDR jack on the
control unit.
2 Plug the other end of the Z200A EMI cord into the SMDR jack on the back
of the CAT.
3 Plug one end of a D8W cord into the PRINTER jack on the back of the
CAT.
4 Plug the other end of the D8W cord into a 355A adapter.
5 Plug the 355A adapter into the serial port on the back of the printer.
6
Set the appropriate printer options for SMDR.
See "Setting Printer Options and DIP Switches," later in this chapter, for
instructions.
Installing the PC, CAT, or Printer 5-9