AT&T MERLIN LEGEND Release 3.0 Installation Manual page 101

Installing Adjuncts
5 To connect an adjunct to an analog multiline telephone:
a Connect a 4-pair cord to the OTHER jack on the telephone.
b Connect the other end to the VT jack on a General Purpose Adapter
(GPA).
c Connect the cord from the adjunct to the TEL/EQUIP jack on the GPA.
d Go to Step 7.
Refer to "General Purpose Adapter" below for additional information.
6 lnsert the other end of the adjunct cord directly into the port for the
logical ID on the 012 module as indicated on the system form. Go to
Step 7.
7 Test the adjunct by dialing its associated extension.
General Purpose Adapter
A General Purpose Adapter (GPA) lets you connect a T/R device--such as a
single-line telephone or modem —to an analog multiline telephone. The device
must be touch-tone, not rotary.
NOTES:
1. The GPA is intended for answer-only service, unless the telephone has
direct access to a line. It does not have touch-tone receivers or pulse dial
detectors; therefore, the associated analog muitiline telephone must dial
calls.
2. The GPA cannot be used with a MERLIN II System Display Console.
3. When the system forms indicate a GPA for installation of an adjunct, follow
the steps below.
1 Plug one end of a 4-pair adjunct D8AC cord into the VT jack on the back
of the GPA.
2 Plug the other end into the OTHER jack on the underside of the analog
multiline telephone.
3 Plug the cord from the adjunct into the TEL EQUIP jack on the GPA.
3-24 Installing Telephones and Adjuncts