AT&T MERLIN LEGEND Communications System PBX System Planning Manual page 89

Trunks
1 .
2 .
3 .
4 .
5 .
6 .
7 .
3-34 Trunk Options
Planning Form Instructions
Complete one "Non-Complex Configuration" pafe of Form 3c for each 100D
module. Label the top right corner of the copies "Page 1 of ____" (1, 2, 3).
On each page:
Write the module number (1, 2, 3).
modules (maximum of 3 per large system).
Fill in the control unit slot number. (Refer to page 1 of Form 3c.)
In the "Services" section:
Check the box next to each emulated trunk or service that will be
connected. Check only those services allowed on the type of service (T1
or ISDN-PRI) selected for the module.
Circle the channel(s) to which each emulated trunk or service will be
assigned.
Note: No channel should show more than one trunk or service, and the
24th channel cannot be used if the signaling type is common channel.
If the type of service is ISDN-PRI, complete the "ISDN-PRI Identification
Service" section.
Do one of the following:
Check the "No" box if you are not planning to use the number
identification service. Continue to step 6.
Check the "Yes, for" box if you are planning to use the identification
services and check the service planned:
For incoming calls, check "ANI", "SID", or "Both." If both automatic
and station identification service are planned, indicate the order in
which the informtion should be displayed (ANI then SID or SID
then ANI).
For outgoing calls, check either "ANI" or "SID" to indicate the
service planned.
own caller identification information, check the box labeled
"SID/ANI Privacy."
Note: The availability of the caller identification information may be
limited by local-serving (caller's) jurisdiction, availability, or central office
equipment.
In the "Channel Service Unit" section:
Check the box that describes the channel service unit used.
using one of the two AT&T models, check the third box and write in the
manufacturer information that describes the unit.
Forward all copies of this page along with a copy of the "General
Business Systems T1/ISDN PRI Planner" (Pages 5-7 or Form 3c) to Tier
III, General Business Systems, National Technical Service Center.
Indicate the total number of 100D
If you are planning to prevent sending out your
If you are not