AT&T MERLIN LEGEND Communications System PBX System Planning Manual page 128

Features
Delay Announcement
See "Call Restrictions" in this chapter for
information on toll restriction.
Message Waiting Receiver
Planning Form Instructions
Under the "Hunt Type" heading on Form 6e, do one of the following:
Check "Circular" to keep the Factory-set hunting pattern.
Check "Linear" to change the factory-set hunting pattern.
Delay Announcement allows you to designate an announcement device to play
messages to callers. The announcement plays once for each call that is placed
in the queue.
The device designated for Calling Group delay announcement can be any
device connected directly to the control unit on a 008 OPT or 012 basic
telephone module. Also, the device can be connected to digital/lSDN (MLX)
telephones using a Multi-Function Module (MFM) in the tip/ring mode.
Only one announcement device can be designated for each calling group;
however, more than one calling group can use the same announcement device.
The announcement device should not be assigned as a group member, and it
must be outward restricted to prevent anyone attaching a telephone and dialing
unauthorized calls.
Planning Form Instructions
Under the "Delay Announcement" heading on Form 6e:
1. Do one of the following:
Check "No" if you do not want an announcement device and continue to
the "Message Wating Receiver" instructions.
Check the second box to designate an announcement device. Write the
extension number for the device in the space provided. (Refer to Form 2a
or 2b.)
Locate the copies of Forms 4b, 4c, and 5b that describe the device(s) you
are designating for delay announcement use.
In the "Type" or "Adjuncts" section under "Answering Machine":
2 . Check the box that indicates that the answering machine is used as a
delay announcement device.
3 . Write the calling group extension number(s) for the group(s) using the
d e v i c e .
4 . Verify that "Outward Restrict" is the selected Call Restriction option.
Message Waiting Receiver allows you to designate a telephone to receive
message-waiting indications for the group. The message receiver for a calling
group does not have to be a member of the group.
Each calling group can have only one telephone assigned as its message
receiver. The same telephone can be assigned as the message receiver for
more than one calling group.
Group Assigned Features 4-23