Setting The Time And Date - AT&T Merlin II Feature Module 2 System Manual

Setting the Time and Date

SET THE DATE
In order to set up or add to this file on your PC you need to use a text editor.
Use either EDLIN, the MS-DOS line editor, or another text editor you are
familiar with.
The following are the commands you need in your AUTOEXEC.BAT file to
start CMS automatically:
cd cms
cms
If your hard disk does not have an AUTOEXEC.BAT file, you can use EDLIN
(the MS-DOS line editor) to create one for the cms commands as follows:
1 At the C> prompt, type cd , then press
2 Type edlin autoexec.bat , then press
prompt, type i , then press
3 At the
4 At the 1: prompt, type
5 At the 2: prompt, type cms , then press
6 At the 3: prompt, hold down the
.
[ ]
7 At the
prompt, type e , then press
You should now be at the C> .
The date and time are important parts of your daily CMS statistics and must
be represented correctly on your PC screen. When you have set up your PC
and copied the MS-DOS program onto the hard disk, the system prompts
you to check the date and the time to be displayed on the screen. If either is
not correct, follow the procedures below. (When in CMS, you can check the
time and date by looking at the right-hand corner of any CMS Menu screen).
NOTE: The date must be changed at the beginning of each year, and
the time must be adjusted for daylight savings time.
To check or change the date on your PC, do as follows:
1 When the C> prompt appears, type
date
and press .
[ ]
The following message appears on your screen:
Current date is Wed 4-07-1987
Enter new date: (mm-dd-yy)
2 If the date is correct, press
If the date is incorrect, type in the correct date (for example, 4-08-1987)
and press .
[ ]
.
[ ]
.
[ ]
.
[ ]
cms then press
cd
, [
[ ]
and
[ Ctrl ]
[ z ]
.
[ ]
.
[ ]
Installing the CMS Software 3-7
.
]
.
keys together, then press