Table of Contents
Advertisement
Subset Finishing
Common Controller
6.
Finishing
The following section contains information about how to use
subset finishing and mixed stacking on a printing job.
The finishing information below does not apply to Continuous
Feed (CF) systems. For CF systems, the finishing configuration
is defined at the CF (STAMPA) Controller. CF imposition files are
used to impose documents for printing in conjunction with
specific CF finishing configurations.
Subset finishing is the capability to use different types of finishing
(or no finishing) within the same job. The ability to finish subsets
independently is a critical feature for many variable data
applications
This product allows more than one type of finishing within a
single PostScript job. The supported finishing options and the
output locations that can be used vary depending upon the
printer type. The finishing options and delivery locations are the
following:
DocuTech 61xx:
•
Portrait Stitch
•
Landscape Stitch
•
Dual Stitch
•
Right Portrait Stitch
•
Right Landscape Stitch
•
Right Dual Stitch
•
Bind
•
Right Bind
NOTE: The DT 61xx printers allow Short Edge Feed (SEF) only
in paper tray 3, 4, and 5. The short edges of the stocks range
from approximately 10 inches to 14 inches (254mm to 300mm).
6-1
Advertisement
Table of Contents
