User Line 2 Link Messages; Check Device Connection Messages - Dell 5310n - Workgroup Laser Printer B/W Service Manual

User line 2 link messages

If the printer is locked on a particular link, the link indication displays. If the printer is ready to process any link,
no messages display. Link messages are listed in the following table.
User message
Parallel
Serial
Serial x
Network x
LocalTalk x
Infrared
Infrared x

Check device connection messages

The messages in the following table display when the printer loses communications with one of the following
devices.
User status message
Check Env Feeder
Connection
Check Tray x
Connection
Check Duplex
Connection
The messages in the following table can occur in two ways. The specified device could have been removed from
the printer, for instance to clear a paper jam. Otherwise, the device can still be attached to the printer, but is
experiencing a communications problem, not fully connected, or having a hardware failure.
If the device is temporarily removed or not connected properly, then the user is advised to reattach it. When the
option is recognized, the printer automatically clears the error and continues. If the option is experiencing a
hardware problem, turn the printer off and back on. If the error occurs again, the user is advised to turn the
printer off, remove the option, and call for service.
User status message
Turn Printer OFF to
Enable Option
Insert Duplex Front
Cover
Close Duplex Rear Door
Explanation
Standard Parallel Port, if available.
Standard Serial Port, if available.
Serial Port is attached to PCI connector x, where x=1, 2, or 3.
Network card x is attached to PCI connector x, where x=1, 2, or 3.
LocalTalk Card x is attached to PCI connector x, where x=1, 2, or 3.
Standard Infrared port, if available.
Infrared Port x is attached to PCI connector x, x=1, 2, or 3.
Explanation
Check envelope feeder connection.
Check tray x, where x=1, 2, 3, 4, or 5.
Check duplex option connection.
Explanation
A printer option, Input Tray, or Envelope Feeder has been attached while the
printer is powered on. To use the option, the printer must first be powered off and
back on again. Data loss results if print jobs are active when the printer is power
cycled. If a print job is active, then remove the option and finish the job. The printer
automatically clears the message once the option is removed. Once the job is
complete, turn off the printer and attach the option again.
The duplex front access cover is not installed.
The duplex rear door is open.
Diagnostic information
2-43