Staplesmart Finisher Service Check - Dell 5310n - Workgroup Laser Printer B/W Service Manual

StapleSmart finisher service check

Note: When removing the stapler mechanism from the option, first remove the staple supply cartridge.
Note: When replacing staples in the supply cartridge, discard any old staples in the cartridge, and replace with
a fresh strip.
Problems with static electricity buildup
FRU
Top cover
1
Printer does not recognize StapleSmart finisher option as being installed
FRU
StapleSmart finisher option
1
Stapler motor/drive
2
assembly
stapler card assembly
Close Finisher Top Cover
FRU
Top cover assembly
1
Top cover switch stapler
2
card assembly
Close Finisher Side Door
FRU
Side cover door
1
Service Manual
2-124
Action
Make sure the brush is attached to the top cover assembly, the
ground clips are installed, and the brush is grounded.
Action
Ensure that the StapleSmart finisher is the only option that is not
recognized by the base printer. If the finisher is the only option not
recognized by the printer, continue with step 2. If not, check the
autoconnects of the options not recognized and the interconnect card
and cable connectors.
Check the autoconnects for signs of damage, especially the
connector pins. Remove the right side cover, and check the cables at
J1A, J1B (bottom autoconnect), J14A, J14B (top autoconnect) to the
stapler card assembly to make sure they are attached securely.
Check the voltages at the printer top autoconnect. If incorrect,
remove the finisher option, and go to
voltages are correct, reinstall the finisher option, and check the
voltages at J1A and J1B on the connector. If correct, replace the
stapler card assembly. If incorrect, replace the stapler option.
displayed—unable to clear or reset message (POST incomplete)
Action
Check the top cover assembly to ensure that it is actuating the top
cover switch and the cover is opening and closing correctly.
Check continuity of the stapler top cover open switch. If incorrect,
replace the switch assembly. If correct, replace the stapler card
assembly.
displayed—unable to clear or reset message (POST incomplete)
Action
Check the stapler access door for any signs of damage or broken
parts. Make sure the door correctly actuates the stapler side access
door switch. If this does not fix the problem, replace the stapler
option.
"Autoconnect" on page
5-7. If