Table of Contents
Advertisement
Locate the integrated tray autocompensator assembly (B) on the bottom of the printer, and disconnect the
6.
autocompensator arm bias spring (C).
Note: When you remove the spring, note the larger loop attaches to the side frame.
Remove the C-clip (D) that rests against the right side frame from the autocompensator pivot shaft.
7.
Disconnect the autocompensator sensor cable (E) from the assembly.
8.
Remove the autocompensator assembly mounting screw (F).
9.
Slide the shaft to the right, and push the shaft from the outside of the frame.
10.
Remove the integrated tray autocompensator assembly.
11.
Repair information
4-51
Advertisement
Table of Contents
