Table of Contents
Advertisement
User attendance messages (continued)
Error
Sub
Primary message
code
code
Check Duplex
Connection
Check Tray x
Connection
Close Finisher Side
Door
Close Finisher Top
Cover
Delete All Jobs
Go/Stop?
Description/action
This messages displays for the following conditions:
• The duplex option may have been removed from the printer, possibly to
clear a paper jam or to remove the option.
• The duplex option may be attached to the printer but a communications
problem may prevent the printer from detection. For example, there may
be a poor connection or a hardware failure.
The following actions may be taken:
• If the option was temporarily removed or not connected properly,
reattach or reconnect it.
• Press
to execute a configuration change which notifies the printer the
option has been hot unplugged (removed with the power on).
Note: This action is not available if the printer is in Diagnostics Mode or
running diagnostics.
• If the device is experiencing a hardware problem, turn the printer off and
on. If the message continues to be displayed, go to
service check" on page
Tray x=Tray 2, Tray 3, Tray 4, or Tray 5
This messages displays for the following conditions:
• The specified device may have been removed from the printer, possibly
to clear a paper jam or to uninstall the option.
• The option may be attached to the printer but a communications problem
may prevent the printer from detecting the option. For example, there
may be a poor connection or a hardware failure.
The following actions may be taken:
• If the option was temporarily removed or not connected properly,
reattach or reconnect it.
• Press
to execute a configuration change which notifies the printer the
option has been hot unplugged (removed with the power on).
Note: This action is not available if the printer is in Diagnostics Mode or
running diagnostics.
• If the device is experiencing a hardware problem, turn the printer off and
on. If the message continues to be displayed, go to
service check" on page
Close the finisher side door. If the message does not clear automatically
when the door is closed, go to
page
2-124.
Close the finisher top cover. If the message does not clear automatically
when the cover is closed, go to
page
2-124.
When the user has selected the Print and Hold Delete All Jobs selection, this
message is displayed. The following actions may be taken:
• Press
to confirm the selection. All jobs are deleted.
• Press
or
to cancel the delete operation.
"Duplex option
2-82.
"Input tray(s)
2-103.
"StapleSmart finisher service check" on
"StapleSmart finisher service check" on
Diagnostic information
2-33
Advertisement
Table of Contents
