F. Switch/Sensor PCB
1) Remove the upper cover unit.
2) Remove the right rear and rear covers.
3) Remove the left rear cover.
4) Remove the connector, the 2 screws,
and then the fan duct.
5) Remove the 4 screws.
Connector
Screws
Fan duct
Screws
Figure 3-7-8
6) Remove the 3 screws and the shield
cover.
Screws
Shield cover
Figure 3-7-9
7) Remove the 5 screws and the shield
plate.
Screws
Shield plate
Figure 3-7-10
8) Remove the DC controller PCB
following steps 1-3 on Page 3-33.
9) Remove the 3 screws and take out the
DC controller mounting plate.
Screws
DC controller mounting plate
Figure 3-7-11
CHAPTER 3
3 - 35