Safety Information; Iii. Safety Information - Canon LBP 2460 - B/W Laser Printer Service Manual

III.

SAFETY INFORMATION

A. Laser Safety
An invisible laser beam is irradiated within
the laser/scanner unit.
Since the laser beam can injure the eye if
it strikes it, be sure not to disassemble the
laser/scanner unit. It cannot be adjusted in
the field, anyway.
The label shown below is attached to the
laser/scanner unit cover.
DANGER-
Invisible laser radiation when open.
!
AVOID DIRECT EXPOSURE TO BEAM.
CAUTION- INVISIBLE LASER RADIATION WHEN OPEN.
AVOID EXPOSURE TO BEAM.
ATTENTION -
RAYONNEMENT LASER INVISIBLE EN CAS D'O UVERTURE.
EXPOSITION DANGEREUSE AU FAISCEAU.
VORSICHT - UNSICHTBARE LASERSTRAHLUNG.WENN ABDECKUNG GEÖFFNET.
NICHT DEM STRAHL AUSSETZEN.
ATTENZIONE - RADIAZIONE LASER INVISIBILE IN CASO DI APERTURA.
EVITARE L'ESPOSIZIONE AL FASCIO.
PRECAUCION - RADIACION LASER INVISIBLE CUANDO SE ABRE.
EVITAR EXPONERSE AL RAYO.
VARO! - AVATTAESSA OLET ALTTIINA NÄKYMÄTTÖMÄLLE
LASERSÄTEILYLLE. ÄLÄ KATSO SÄTEESEEN.
VARNING! - OSYNLIG LASERSTRÅLNING NAR DENNA DEL ÄR ÖPPNAD.
BETRAKTA EJ STRÅLEN.
ADVARSEL! -
USYNLIG LASER STRÅLING,NÅR DENNE ER ÅBEN.
UNDGÅ BESTRÅLING.
ADVARSEL -
USYNLIG LASERSTRÅLING NÅR DEKSEL ÅPNES.
UNNGÅ EKSPONERING FOR STRÅLEN.
Figure 1-3-1
B. Toner Safety
Composed of minute, plastic, colored
components, toner is a non-poisonous
substance.
If toner adheres to your skin or clothes,
remove as much of it as possible with a dry
tissue, then wash with cold water. If you
use hot water, the toner will gel and become
difficult to remove.
As toner easily breaks down vinyl
materials, avoid letting toner come into
contact with vinyl.
C. Ozone Safety
An infinitesimal amount of ozone gas (O
is generated during corona discharge from
the charging roller used in this printer. The
ozone gas is emitted only when the printer
is operating.
This printer meets the ozone emission
reference value set by Underwriters
Laboratory (UL) at the time it is shipped
from the factory.
D. Power Supply Unit Safety
Care is needed as even though the printer
switch may be OFF, there is a possibility
that a current may still flow on the primary
side. Be sure to remove the power plug
before disassembly and assembly of this
printer.
CHAPTER 1
)
3
1 - 7