I. Power Supply - Canon LBP 2460 - B/W Laser Printer Service Manual

H. Cassette-size Sensing PCB
1) Remove the cassettes.
2) Remove the power supply following
steps 1-6 on Page 3-37.
3) Disconnect the connector, remove the
screw, then take out the cassette-size
sensing cover.
Connector
Screw
Cassette-size sensing cover
Figure 3-7-14
4) Disconnect the connector from each
PCB, remove the 3 screws, then take out
the cassette-size sensing PCBs.
Connectors
Screws
Upper-cassette-size sensing PCB
Lower-cassette-size sensing PCB
Figure 3-7-15

I. Power Supply

1) Remove the left rear and rear covers.
2) Disconnect the connector, remove the 2
screws, then take out the fan duct.
Connector Screws
Fan duct
Figure 3-7-16
3) Remove the connector.
4) Take out the 5 screws.
Connector Screws
Figure 3-7-17
CHAPTER 3
3 - 37