Paper Transport System; Pick-Up Unit - Canon LBP 2460 - B/W Laser Printer Service Manual

CHAPTER 3
III. PAPER TRANSPORT
SYSTEM
A. Pick-up Unit
1. Removal from the printer
1) Pull out the upper and lower cassettes.
2) Perform steps 1-6 on Page 3-17 to
remove the manual feed pick-up unit.
3) Remove the right cover.
4) Undo the connector.
Connector
Figure 3-3-1
5) Perform steps 1-2 on Page 3-20 to
remove the pick-up, feed and separation
rollers.
6) Remove the cable from the guide.
3 - 12
7) Remove the 4 screws, and take out the

pick-up unit.

Cable Cable guide
Screws Pick-up unit
Figure 3-3-2
Note: 1. While replacing parts in the
pick-up unit, to prevent grease
from getting on the pick-up, feed
and separation rollers, be sure to
remove them before working on
the unit. Take care not to get
grease on the paper feed guide.
2. Be sure to grease the gears
shown in figure 3-3-3 when
exchanging, to prevent noise.
The type of grease (do not use
grease other than the specified
type) and the method of
application is explained below:
Grease: Permalub SHV-2
Application method: Apply a
small amount of grease to 3 or
more continuous cogs on the
gear.