CHAPTER 3
7. Removal of the Separation Lower
Roller, Separation Upper Roller and
Torque Limiter
1) Follow steps 1 to 5 on page 3-40 to
remove the pick-up motor.
2) Remove the drive unit.
3) Remove the 2 E-rings and 2 bushings,
then take out the separation lower roller
shaft. Remove the separation lower
roller from the shaft.
E-rings
Bushings
Separation lower roller
Figure 3-8-17
3 - 44
4) Remove the separation lower shaft from
the guide. Then take the separation
upper roller and torque limiter off the
shaft.
Guide
Separation upper roller
Torque limiter
Figure 3-8-18