Canon LBP 2460 - B/W Laser Printer Service Manual page 208

CHAPTER 3
3. Assembly
a. Front wire
1) Insert the pulley alignment pin in the right side(looking from the front) of the shaft.
2) Wind the wire one and a half times starting from the second groove from the front of pulley 1
and insert it on to the shaft.
3) Wind the wire one and a half times starting from the second groove from the back of pulley 2
and insert it on to the shaft.
4) Secure the pulleys with the E-ring.
Shaft
Pulley alignment pin
Wires
Pulley 1
Pulley 2
E-ring
3 - 66
Figure 3-11-42