Canon LBP 2460 - B/W Laser Printer Service Manual page 178

CHAPTER 3
10) Disconnect the connector, remove the 2
screws, and pull out the board.
Disconnect the other connector and
remove the switch/sensor PCB.
Connectors
Screws
Switch/sensor PCB
Figure 3-7-12
3 - 36
G. High-voltage Power Supply PCB
1) Remove the right rear and rear covers.
2) Disconnect the 2 connectors, remove the
4 screws, then take out the high-voltage
power supply unit.
Connectors
Screws
High-voltage power supply unit
Figure 3-7-13
3) Disconnect the 2 claws and remove the
high-voltage power supply PCB.