Canon LBP 2460 - B/W Laser Printer Service Manual page 247

Message
14.2 PAPER JAM Paper jam has occured in the feed cover.
OPEN RIGHT
COVER
14.3 PAPER JAM Paper jam has occured in the feed cover.
OPEN RIGHT
COVER
OPTIONS Option controller error with paper deck.
CONTROLLER
DUPLEX COVER The delivery cover is open.
OPEN
OPT CONTROLLER There is a problem with the Option
ERROR Controller
OPT CONTROLLER There is a problem with the Option
COMMUNICA TIONS Controller
ERROR
MEMORY Memory overflow. The printer received
OVERFLOW more data than it can fit into its available
memory. This can happen if too many soft
fonts, macros, or graphics which are too
complex are received.
ERROR DISK CALL Hard Drive Failure - Read Error -
FOR SERVICE
MEMORY ALLOC GRS has been unable to allocate the
ERROR memory it needs.
Bad NIC in slot 1.
1 NETWORK
OPTION ERROR
2 NETWORK Bad NIC in slot 2.
OPTION ERROR
43 PS OPTION Option PS ROM (DIMM) diagnostic error.
ERROR
EXP I/O ERROR: LocalTalk error, where ## is the number.
## 00 Shared Memory test error
01 CRC receive error
02 Receive over-run error
Meaning
CHAPTER 4
Action
must be opened and closed to
resume. printing.
Check the Paper Deck. Remove
the jammed paper from the
paper path. The upper cover
must be opened and closed to
resume. printing.
Check the Paper Deck. Remove
the jammed paper from the
paper path. The upper cover
must be opened and closed to
resume. printing.
Reconnect the paper deck to the
printer.
Close the cover.
Replace the option controller.
Replace the option controller.
The job will resume after 10
seconds if AUTOCONT is ON.
Otherwise press the CONTINUE
key to resume printing. Check the
page that ejects since the could not
be processed as requested. Also
simplify the job or add additional
memory.
Replace the hard disk.
The job will resume after 10
seconds if AUTOCONT is ON.
Otherwise press
CONTINUE key to resume
printing. Check the page that
ejects since the could not be
processed as requested.
Replace the NIC.
Replace the NIC.
An option ROM has failed its
startup checksum and needs to
be replaced.
These are problems with the
8051 (LocalTalk) card. These
errors will be displayed and the
printer will halt.
4 - 33
the