CHAPTER 3
B. Sorter Driver PCB
1) Following the rear cover removal proce-
dure on Page 3-2, remove the rear cover.
2) Remove the 2 screws, disconnect the 9
connectors, and then holding the 2
claws, take out the sorter driver PCB.
Claws
Screws
Figure 3-6-2
3 - 16
Sorter driver PCB
Connectors
C. Paper Sensor PCB
1) Following the rear cover removal proce-
dure on Page 3-2, remove the rear cover.
2) Remove the 2 screws and then the 2
PCB mounts.
Screws
Figure 3-6-3
3) Disconnect the connector, and then
remove the paper sensor PCB.
Connector
Figure 3-6-4
PCB mounts
Paper sensor PCB