Removing The Left Cover; Removing The Fixing Film Unit - Canon LBP3200 - LBP 3200 B/W Laser Printer Service Manual

Chapter 3
[1]
[4]
F-3-153
3.5.2.6 Removing the Left
Cover
1) Remove the screw [1].
2) Free the claw [2] at the rear; then, free the claw [4]
at the front bottom as by sliding the bottom of the
left cover [3] to the front.
3) While opening the bottom of the left cover [3]
slightly toward the outside, slide upward to detach
the left cover.
[3]
[2]
[4]
F-3-154
3.5.2.7 Removing the Fixing
Film Unit
1) Remove the 2 screws [1], and detach the fixing
cover.
3-40
[3]
[2]
0002-3729
[1]
0002-3731
[1]
[2]
F-3-155
2) Remove the 2 screws [1], and detach the fixing
entrance guide [2] by sliding it to the left and right.
[1]
[2]
F-3-156
3) Disconnect the connector [1] of the engine
controller board, and free the cable from the cable
clamp.
4) Disconnect the connector [2] of the power supply
board.
5) Remove the left/right pressure spring and
grounding spring [3].
6) Remove the left/right pressure plate [4].
[4]
[3]
[2]
[3]
F-3-157
[1]