Power Supply Board - Canon LBP3200 - LBP 3200 B/W Laser Printer Service Manual

[1]
[2]
F-3-17
3.1.6.4
Removing the Left
Cover
1) Remove the screw [1].
2) Free the claw [2] at the rear; then, free the claw [4]
at the front bottom as by sliding the bottom of the
left cover [3] to the front.
3) While opening the bottom of the left cover [3]
slightly toward the outside, slide upward to detach
the left cover.
[3]
[2]
[4]
F-3-18
3.1.6.5 Removing the Engine
Controller Board
1) Disconnect the 5 connectors [1], and remove the 3
flat cables [2].
2) Remove the 3 screws [3], and detach the engine
controller board [4] while paying attention to the
sensor flag.
0002-3586
[1]
0002-3587
[1]
[2]
F-3-19

3.1.7 Power supply board

3.1.7.1 Removing the Cassette
1) Remove the cassette by holding the cassette handle.
3.1.7.2 Removing the Front
Cover
1) Open the front cover [1], and free the claw [2] of the
arm to separate.
2) Remove the left/right shaft [3], and detach the front
cover.
[1]
[3]
F-3-20
3.1.7.3 Removing the Rear
Cover
1) Open the face-up cover [1], and remove the left/
right shaft [2]; then, detach the face-up cover.
Chapter 3
[2]
[3]
[4]
[3]
0002-3735
0002-3736
[2]
0002-3738
3-5