Crossfill - Garmin GTN 750 Pilot's Manual

16.4.1.4
Foreword
Dual units may be interfaced to crossfill information between the two units.
This option will not be available unless dual units are configured.
Getting
Started
When Crossfill is turned on with one GTN, it is automatically turned on in the
other GTN. Some items are always crossfilled regardless of the crossfill setting;
Audio &
Xpdr Ctrl
others are dependent on the crossfill setting.
Com/Nav
NOTE: Upon crossfill being activated, the GTNs may take up to 10 seconds
to crossfill the flight plans. The pilot must verify the flight plan in each unit
FPL
prior to use.
This data is always crossfilled:
Direct-To
• User waypoints
Proc
• Flight plan catalog
Charts
• Alerts (traffic popup acknowledgement, missed approach waypoint
popup acknowledgement, altitude leg popup acknowledgement)
Wpt Info
• External sensors (transponder status and commands, synchro heading)
Map • System setup:
- Favorite NAV frequencies
Traffic
- Date/Time convention
Terrain
- Nearest airport criteria
- Units (Nav angle, Distance/Speed, etc.)
Weather
- Favorite COM frequencies
Nearest
- Ownship icon
- CDI Scale setting
Music
- ILS CDI Capture setting
Utilities
This data is crossfilled only if crossfill is turned on by the pilot:
• Active navigation (flight plan)
System
Messages
Symbols
or
Appendix
16-18
Index

Crossfill

1. While viewing the System Setup page, touch the Crossfill key
to toggle between Enabled and Disabled Crossfill.
2. When Crossfill is about to be enabled, you will be prompted
to note that data will be overwritten in the other unit. Touch
OK to enable Crossfill or touch Cancel to return to the System
Setup page without enabling Crossfill.
Garmin GTN 725/750 Pilot's Guide 190-01007-03 Rev. B